Posted by John T on August 10, 2012 at 04:33:08 from (216.249.82.117):
In Reply to: timing by ear posted by picassomcp on August 09, 2012 at 20:57:03:
Like many "old farmers" or "shadetree mechanics" I have timed by ear now n then and heres what I think.
A lot of folks tend to have the timing too darn fast if by ear, cuz they advance it too far since it sounds smoother n quiter and a bit faster that way HOWEVER its been my experience if you throw a timing light on them after that, youre too fast !!!!!!! Therefore I slowly advance it till she say stops popping and speeds up and gets fairly quiet BUT THEN I RETARD IT JUST TO WHERE SHE SOUNDS A BIT LOADED N A TAD LOUDER AND A TAD SLOWER RUNNING.....
If timed too fast she wants to bump the starter (kickback as it fires too much before TDC) but if too slow she cranks faster but dont start as well...
Thats my experience as a used tractor dealer anyhow, others Im sure have different methods USE A LIGHT FOR BEST RESULTS
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.