Posted by pete 23 on September 02, 2012 at 13:10:07 from (74.32.238.2):
In Reply to: 806 International posted by TMH on September 02, 2012 at 11:38:30:
You cannot get the outer plate off until you remove the pump, clutch pack and drum which is all done from the other side. You have to pull the whole unit off and take it apart. You can replace the 1000 rpm seal from the outside but the 540 seal is installed from inside. You need a few special tools that can be made to compress spring of clutch piston and brakes.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
