mkirsch said: (quoted from post at 09:30:38 09/19/12) Can you give us some more details on the situation?
Is the tractor new to you?
Was the tractor recently serviced?
Did it work fine, and then suddenly one day develop this problem?
ok i had the engine overhauled about 200 hours ago the guy sent my old clutch and pressure plate out to a rebuilder also replaced the throwout bearing. it was close to the bottom prior that slowly getting hard to get in gears. i crawled under and had another look last night the fork that bolts to the cross shaft looks like its been spread apart some how theres a big gap between it and the throw out bearing carrier so im thinkigs its a combination of all the slop looks it going to to have to have another fork before long thanks for all your help guys. I dont guess theres a chance of getting the cross shaft unbolted and out from the fork with out splitting the tractor ?
This post was edited by tn terry t at 04:19:11 09/20/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
