Posted by glennster on September 26, 2012 at 19:10:10 from (99.90.9.201):
In Reply to: W-9 Valve Cover Gasket posted by Tobaccoman on September 26, 2012 at 17:30:47:
it may only be available in a valve grind set, parts are pretty hard to get for the 9. your other option is to by a gasket sheet from napa and make your own gasket. they have several sizes in pretty large rolls that would be enough to make the gasket. you could also try berkshire equipment in royal center indiana, they have a lot of discontinued and hard to get i-h parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
