Posted by Dean Olson on September 30, 2012 at 16:42:43 from (98.196.66.64):
In Reply to: Tire Size SH posted by Va Gasman on September 30, 2012 at 05:36:38:
I had 11.2's on 10" rims and went to 12.4X38" tires on those same rims. I would have gone to 13.6's but couldn't justify looking for 12" rims.
All the advice I was given by my local tire guy and what I have read on here says you can 2" bigger tire size that what your rim is.
I've seen some 13.6's on 10" rims and they looked a little big but seemed to work.
I bought a pair of 15.5X38" on 10" rims and that looked like crap and the tread was dome shaped instead of being flat. I put those tires on a set of 14" rims and it looks perfect on my 300.
1st pic is 54SH with 11.2X38's on 10" rims. 2nd pic is 53SH with 12.4X38" on 10" rims The 11.2's look a little wimpy. Go with the 12.4's
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
