Farmall & IHC Tractors Discussion Board |
Re: Guy Fay's book help!!!!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on October 16, 2000 at 21:01:03 from (208.49.9.67):
In Reply to: Guy Fay's book help!!!!! posted by Paul Shuler on October 16, 2000 at 13:59:23:
Paul, If you received the mylar decals, they are very easy to apply. 1. Lay out the decals so you can see what you have. Determine which ammeter decal you should use by the number of positions on the switch. 3 position switch takes the "O D B" decal. A 4 position one takes the "L H D B" decal. Rotate the switch all the way CCW so you will know where to place the bottom end of the decal. I always trim off the outside white or yellow portion on those that have the solid black line around the outer edge ie; Safety decals and Gear shift pattern. There may be others you want to trim as well. This makes the finished product look "Finished". 2. Using spray liquid windex, mist the area where the decal goes ensuring that the area misted is larger than the decal you are applying. 3. Carefully peel off the backing paper while not allowing the sticky sides to touch. Position the decal on the misted area and then slide it around until you get it in just the right place. Starting in the middle of the decal, sqweegy out the air bubbles in all directions towards the nearest edge. 4. Using an absorbent rag (like a dishtowel), wipe off the excess windex being careful not to move the decal. Wipe lightly and you should be just fine. (The windex will not harm the paint job and anything that doesn't wipe off will evaporate fairly quickly). Repeat the process for each decal. It takes a little time so don't be in a hurry. The end result will be spectacular especially when you know that they are in the right place!//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|