Posted by Zachary Hoyt on October 11, 2012 at 10:06:11 from (184.12.76.190):
In Reply to: 1952 H Cylinder Liner posted by Allan from PA on October 11, 2012 at 07:05:32:
I would check the other pistons and sleeves for wear and decide from there. I got a 300 in the spring that had been left out for years and one piston/sleeve had to be replaced. I decided not to replace the others at the time since there was no ridge on the top of the sleeves and the piston-sleeve clearance did not look excessive. I got the tractor running and so far I am happy with that decision, it runs well with no smoke and has plenty of power. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
