Posted by Lmack on October 17, 2012 at 20:40:35 from (24.131.58.167):
In Reply to: Re: Planter? posted by Jim Becker on October 17, 2012 at 07:47:37:
Yes there was a change for the SC/200 for belly mount planters and it involved the planter hopper mount configuration. The original hopper mount had a double shaft (to allow transfer of the chain drive from the planter drive to pass through the planter hopper mount to the side dresser in a straight line). The original hopper mounts had a short transfer chain mounted to the inside of the main chain drive to transfer the motion from the rear shaft to the front. The addition of the cylinder control for the two point hitch created a conflict with the short inside mounted chain. It was reconfigured to the outside ends for later models. The later models will work on all models including the C but the earlier models will not work on the SC, 200, etc that have the cylinder control without modification to relocate the short chain for the right planter mount and shorten the rear shaft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
