Posted by beargap on October 30, 2012 at 02:26:17 from (50.29.229.183):
Recently had the throwout bearing replaced on my 1950 Farmall Cub with a 12v conversion, but since returning it is running very poorly. It starts, but acts like it is only running on a few cylinders and only seems to run smoothly close to idle until warmed up for 20 minutes or so. When advancing the throttle it will immediately stumble and then run and miss erratically. Any choke after running a few minutes seems to immediately kill the engine. The governor keeps trying to adjust the carb between the hits and misses.
So far I"ve replaced the distributor cap and rotor and all the plug wires. The plugs and points were changed last spring, and the fuel line replaced and a separate inline fuel filter eliminated at the same time. The carb was cleaned then as well and the gaskets replaced. It was running fine through the summer until the throwout bearing broke. Any thoughts?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.