Posted by Tom Fleming on November 04, 2012 at 15:39:08 from (173.233.9.252):
In Reply to: Rust stuck M farmall posted by Ronald Jeter on November 04, 2012 at 12:45:39:
Lots of ways to do it, but it really depends upon how badly they are stuck. Gene gave by far the best overall answer (no offense to anyone else, as most were good answers). If the cylinders just have a bit of "flash" rust on them, you can probably get away with shooting 1/4 cup of your favorite penetrating oil/mix into the cylinders. Let her set for a week or two. Then put it in gear and slightly "rock the tracktor back and forth. When I say slightly, I mean slightly. too much and you will bend connecting rods.
Now, if there is serious rust in the cylinders, do as Gene (and others) said, and tear her down.
This post was edited by Tom Fleming at 15:39:56 11/04/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
