Posted by Tom Fleming on December 29, 2012 at 09:15:25 from (67.20.233.75):
I have a homemade sleeve puller that I bought at a flea market a few years back. Now that I have a lathe, I would like to make some sleeve pulling pucks that actually fit correctly on the sleeves. The ones i have are sloppy and while they work, it is a pain to get them lined up to pull straight since they don't have the correct lip on the to fit inside the sleeve to pull squarely.
basically my question is, where can I find the ID and OD dimensions for the various sleeves for the Letter and F series engines? I have some C-113 sleeves around, so that one is easy.
No hurry on this, but if anyone has some sleeves sitting around that they could measure for OD and ID, then post it on this thread, I would really be grateful. Or, if there is a refernce source that I can get the various measurements, that too would work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
