Posted by agpilot on December 29, 2012 at 14:26:42 from (208.83.190.25):
Hello: I thought I'd post 4 Farmall Auction prices from today at an Estate Auction in Edgerton Mn which is in far SW-MN.. I'll add that it was below zero F early this morning. There was 1-SM Gas, wide front with Wesendorf loader and real good rubber. Paint was nice but a little older.. $6,800.. 2ed was a S-H late model with disk brakes and live hyd. ( I can't tell if live hyd pump was factory or not). Wide front very well worn rear tires and old-old paint. A working tractor. $2,700. 3ed was an older straight M gas. Had live aftermarket hyd pump and used belly pump as resevor.. Very neat job on hyd lines and other small details. Very good paint and decals etc very good rubber. $5,700. 4th was a 450 gas.. Auction people made it clear that this 450 was completly taked apart and rebuilt.. etc etc. Great paint and minor details. Only standard drawbar..$7,700. All tractors seemed to be well taken care of. Owner was retired and had a large garage/workshop full of Many-Maintence tools common to fixeing & restoring old equipment & tractors plus a pile of discarred worn-out parts. Many people there were friends and spoke well of decesed owner.. I think the $7/bu corn prices helped too. Question:. I wondered if other $7/bu Corn-Belt areas have had higher prices for older Farmalls?? My Prices are approx and may be in error by $50 or $100.. as I didn't write anything down with temps around zero degrees... Ag Ret..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Variable pulley for case 1530 skid loader
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
