Farmall & IHC Tractors Discussion Board |
Re: Oil in coolent of Farmall Cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by p on November 09, 2000 at 11:40:51 from (12.33.190.5):
In Reply to: Oil in coolent of Farmall Cub posted by Curt on November 07, 2000 at 17:09:47:
The problem with the two theories is that the cub has no oil near the top of the motor. There is no oil passages that pass to the head because there is no overhead valvetrain. The cub is a flathead design and therefore oly cloolant passes through. A bad head seal would leak into a cylinder or onto the block. I wouldn't worry too much if the water is not in the oil. give everything a GOOD flushing and cleaning and then watch it. If it reappears then you have trouble. Watch the oil!
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|