Posted by 36F30 on March 01, 2013 at 20:20:22 from (97.125.158.63):
In Reply to: F-20 Connecting Rods posted by Bruce Nelson on March 01, 2013 at 10:11:38:
[quote="Nebraska Kirk"](quoted from post at 20:43:10 03/01/13) Quoting Removed, click Modern View to see
Yes, F20 con rod bearings are replaceable insert bearings. Brass backed with babbitt wear surface.
Kirk, while the inserts are somewhat similar to the more modern bearings, the fact they have adjusting shims makes them different and I don't think crush applies like it does on a thin insert. They fit into the rod with a slight interference fit and the thick heavy shell and shims hold them in place. The force necessary to crush them like a modern rod and insert would be huge. Not sure the existing components could take it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.