Posted by old on March 08, 2013 at 17:08:59 from (209.86.226.34):
In Reply to: Stuck engine posted by Brent Holland on March 08, 2013 at 16:25:59:
Water in the cylinder if for a long time little to no hope. Now if say only a month or so maybe but you first have to get the water out by blowing it out or wicking it out etc. The forget the WD40 is will NEVER work. Then do this and it should work. Mix 1 qt of ATF with half a bottle of HEET. By doing that the HEET will absorb the water that is left and the ATF then can soak in and down past the rings to free it up. Put the plugs back in after filling the cylinder and then pour ATF down the exhaust pipe and then cover it. May take a few weeks to free up but doing that you stand I would say a 75% chance it will
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
