Posted by Stumpy(NH) on March 22, 2013 at 15:13:49 from (64.222.184.160):
Does anyone have a shot of the bottom of a light bar toolbox?
I bought one from an aftermarket manufacturer and was very excited...until it arrived. I bought a battery box and cover from this same company and was very pleased. Not this time.
The bottom of the box looks like a 5 year old welded it. I am going to send them an email expressing my displeasure, but think I will be stuck with this. I'll have to make it look as I think it should on my own.
My big gripe is the fact that the bottom of the box was tack welded in with a mig welder. It looks like crap. It should have been spot welded in. I don't think there were so many gaps with the original design, but I can't put my hands on one right now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
