Posted by DeltaRed on March 25, 2013 at 07:37:54 from (71.208.220.227):
In Reply to: Farmall questions posted by Greg Knapp on March 24, 2013 at 18:05:23:
Greg,I'm wondering,why do you want to do such a thing?Do you have am M with a bad motor?350 with a bad rear end?Would be cheaper and easier to just fix the M engine,or drop in a 'replacement'.When you were done with your convertion.You would just have a worthless 'frankentractor'that nobody else would want,underpowered at that.Next thing,how about the hood,steering,etc.Is the clutch pilot spline the same on both tractors?But,If you're up for the chalenge-GO fot it!Then be sure to post lots of pics-of the 'journey' and the completed project.Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
