Posted by billy boy2 on May 10, 2013 at 21:48:51 from (72.251.12.120):
In Reply to: M impulse coupler posted by billy boy2 on May 10, 2013 at 12:59:49:
The impulse looked good by your descriptions. Very strong. I had to put the double possum grip on it to turn it :lol: The pin looked round too . I also noticed you can't turn it backward. I'm guessing the weights stick out and snag on the pin. I thought I had a propane problem, but in the back of my mind I was thinking stuck points. I took it off and apart and checked the impulse and seemed good. Checked the points and they were barely opening and pretty corroded. I cleaned them and put it all back together and it fired a couple of times, then nothing. Now the points have continuity to ground whether opened or closed,but only if the coil in the mag is hooked up. I'll start from there in the morning.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
