Posted by Jesse Landre on May 23, 2013 at 10:46:36 from (71.13.140.14):
Hello-
Can anyone tell me what oil seal goes in the control rod shaft going into the side of a 1942 Farmall H belly hydraulic pump? The parts book has 2 different part numbers 19812D and 494027R1. The 19812D is for shaft 15089E, and 494027R1 is for shaft 15089EA. The parts book only lists the 15089EA shaft, and this is what I have. Called 2 IH dealers, both said 494027R1 is not a valid number with no superceded numbers or info, NLA. Part 19812D still available, but O.D. of the seal is too big 1.375 inches, shaft .75 inches. Has anyone replaced this seal before? My pump had no seal here when I took it apart. OD of housing where seal would go is about 1.14 inches, shaft size is .75 inches. Anyone know a good number for the 494027R1? Thanks in advance for any help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Super Dexta - by Anthony West. The rusty blue tractor caught my eye as my truck zipped by the farm implement business. It looked so fornlorn amongst the lineup of newer equipment. But it was just the right size for my small farm. I stopped in and asked the proprietor for further information. "It's a 64 Ford Super Dexta", he said. "It's a tough little tractor, although it's a hard starter being a diesel and all." He did manage to get it running, compliments of a can of ether. Once started it putted along pretty good. It
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
