Posted by jnf on June 09, 2013 at 17:19:01 from (64.111.52.6):
In Reply to: slipping out of gear posted by mikes54jubilee on June 09, 2013 at 06:26:47:
At the risk of comparing apples from a different tree, I had the same problem when I restored our Minneapolis Moline UB. It would stay in 5th gear only under load. My dad used it for years on a feed grinder/mixer and our standard procedure was to start the loaded mixer in 3rd and do a "grinding shift" to 5th, then proceed to the hog barns. Upon investigation, rounded teeth were the problem. On a UB, 5th gear does not engage as fully as other gears by design, I suppose because of the lighter load. My only remedy was to replace the gears from a salvage tractor (or a bungee cord at first).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
