Posted by PaulW_NJ on June 26, 2013 at 19:54:15 from (74.105.19.166):
In Reply to: 340 farmall loader posted by ph ref on June 26, 2013 at 13:58:37:
Quoting Removed, click Modern View to see
IH Loader manual lists the 2000 and 2001 loaders will fit the 340.
I installed an IH 1701 on my 340U . . . I had to fabricate a few adapter plates. The IH loaders originally came with proper plates for specific IH model tractors, but unless you find an exact replacement from the same tractor, you'll have to fabricate your own.
The 340 had 3 options on hydraulic pump capacity, a 9 gpm camshaft drive, and 12 and 17 gpm trans drive. That sets the speed of your hydraulics.
Some, but not all 340's came with 1,2 or 3 external hydraulic valves: you need two to run a loader. Otherwise you need to add them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
