Farmall & IHC Tractors Discussion Board |
Re: Re: $350 Cub - Need's a lot of help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pau l Shuler on November 24, 2000 at 17:52:56 from (64.12.104.28):
In Reply to: Re: $350 Cub - Need's a lot of help posted by Stan on November 24, 2000 at 16:45:46:
Have you tried reversing the wires on your ammeter. On my C this caused it to show - all the time.Also you might try putting I belive it is a smaller pulley on your alt. to make it spin faster and kick in to charge at a lower RPM. If it is a bigger pulley I'm sure someone can correct me.On my C the ammeter does not show it's charging till I get it up to a pretty good RPM,especially if I have the lights on.On the touch control I know that when I changed the fluid on mine it got a little air in it and took a while to start working again. It would do just like yours move when started and that was it.I belive that there is a screen filter on this unit also but have not dealt with that so I'm not sure about that. Not sure if any of this helps , just a few things I found on my own project.
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|