Farmall & IHC Tractors Discussion Board |
FARMALL 130 12 VOLT CONVERSION PART 2
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeremy on November 26, 2000 at 15:39:16 from (209.240.221.134):
Well, I had an idea. We have an old John Deere out back. It is a 12 volt. I know before it was parked out back it ran. So I took the coil off it (resistor built in), and put it on the 130. Still wouldn't start. Got into the points and shinned them up. SUCCESS! It started and I let it run for a while. When it was warming up the ammeter was between 20 and 30, then dropped down between 10 and 20. The warning light went out. Only thing is the motor has a "miss". Probably in need of points, huh? So tomorrow I should be able to report a complete success. Thanks to all who offered advice. FARMALLERS RULE! Thanks, Jeremy.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|