|
Farmall & IHC Tractors Discussion Board |
Re: Super A steering box
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by haas on December 05, 2000 at 06:49:42 from (129.37.117.214):
In Reply to: Super A steering box posted by David A on December 05, 2000 at 05:27:55:
You can take the big plug on the front of the steering gear out. Then you can turn the shaft and screw the worm gear out toward the front. You may have to take the steering wheel support out to get the shaft to go forward far enough. If you are going to replace the steering wheel shaft seal, you will have to pull the steering wheel off the shaft, or take the worm gear off. I never took off a worm gear so don't know how to do that. You will have to have a puller to get the steering wheel off. There is no adjustment that I know of on the pitman shaft. Sometimes the nut that holds the pitman on gets loose, making play there. You can try tightening the big nut under the bottom that holds it on.
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
