Posted by Hugh McKinney on November 01, 2013 at 11:09:00 from (66.208.143.3):
Okay, after all the help I got in months past, I'm finally reinstalling the Ensign Reg/Vap on my 450 LP. I've had an IMPCO "rigged" into place for the past three years, and for that reason, I don't remember if the Ensign unit bolts directly to the bracket, or if there are spacers between the bracket and the Ensign unit. Anybody out there happen to know? I tried the caseih website but they don't even show the bracket when they illustrate the Ensign unit. Thanks, Hugh
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.