|
Farmall & IHC Tractors Discussion Board |
Re: High crop wheel spacing?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Harold H on December 13, 2000 at 17:26:38 from (207.244.55.19):
In Reply to: High crop wheel spacing? posted by joe on December 12, 2000 at 18:47:58:
Joe, The standard rear tread on the Farmall HV was 60" minimum, 72" maximum. The MV was also the same. Basic demensions of the HV: shipping weight 5055 lbs, wheelbase 91 1/2", height overall 84 1/2", width overall 85 7/8", rear tread 60" min 72" max, cultivating clearance 30 1/4", turning radius 12 3/4 ft, standard tires 6:00 x 20 front, 12 x 36 rear, 13 x 36 optional. Harold H
Follow Ups:
Home
| Forums
Today's Featured Article -
Experimental Tractors Article - by Danny Bowes (Dsl). Tractor technology appears to have nearly hit it's pinnacle of development. If you agreed with the subtitle, you are rather mistaken. Quite, actually. As a matter of fact, some of the technology experimented with over 40 years ago makes today's tractor technology seem absolutely stale by comparison. Experimentation, from the most complex assembly to the most simple and mundane component, is as an integral a part of any farm tractor's development
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
