Posted by Al BAker (pumpman) on January 31, 2014 at 20:41:20 from (96.42.135.158):
In Reply to: Re: 650 diesel governer posted by 450dieselfan on January 30, 2014 at 20:02:30:
Run the oil in the crankcase of the pump. Run it for a few hours, then drain out and replace with a good 15/40. If you are getting fuel leaking out the vent, then your lift pump drive seal is in need of replacing. I had trouble finding the last one I changed a few months ago. Case I-H dropped the seal from their stock. Cost for this seal with shipping will eat up a $100.00 bill. It isnt any bigger than a nickel in size, but they bend you over when you need one. Wish I had bought a doozen extra back when I could. Havent found a source for this seal now. Good Luck. Al Baker 231/757/0064
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.