Posted by Janicholson on March 13, 2014 at 20:03:23 from (74.60.94.18):
In Reply to: Plow Pulls Sideways posted by big_red_man on March 13, 2014 at 19:31:12:
If it is pulling such that the beams tend to drag toward the left (un turned earth) the land slides, or their adjustment is suspect. letting it pull crooked takes power away from productivity. The land slides should be aligned with the beams. Careful measurement can be done by using a flat wall position the plow so the beams are parallel with the wall, and measure perpendicular to the wall to the left edge of the shin, and the rear of the land slide. (assumes the plow is sitting level on flat ground or concrete) Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
