Posted by Red Mercury on March 28, 2014 at 22:42:36 from (204.112.17.140):
In Reply to: What is a W9 worth? posted by T in NE on March 27, 2014 at 09:40:32:
2pipe said: (quoted from post at 04:01:58 03/29/14) FYI That live hyd pump off of your W9 won't fit on an M, it is too big and the bolt holes aren't in the right places.
I suspected the same thing. Years ago, I measured a WD-9 pump with the intention of putting it on a WD-6 .it looked like it should fit ..but the mounting holes were not where they needed to be. I would bet that a W-9 to M hydraulic pump transplant would have the same problem.
As for the aftermarket websites that say it should fit, they often have errors in the list of applications. The safest bet is to check the part numbers in the original IH parts manuals and see if they match.
This post was edited by Red Mercury at 22:44:37 03/28/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
