Posted by George Cameron on April 22, 2014 at 08:07:13 from (72.168.98.119):
I'm getting ready to rebuild the hydraulic lift and power steering assist assemblies on my IH 354 and am confused about some o-ring descriptions in my parts book.
Here is a typical book entry:
352 221 R1 "O" RING, 9/16" x 3/4" x 3/32" (class 6)
I understand the sizing alright, but what is "class 6"? Is it o-ring material? I expect most of the seals in these assemblies are buna-n (nitrile). I don't want to pay many dollars for single o-rings that should cost a few cents unless it is necessary for the specific application.
How do I find dimensions for o-rings that are called out by part number without the description? It would be easier to have dimensions than to measure grooves and old o-rings to come up with a fit. It's not hard, but I could have the seals purchased and on hand before the disassembly begins.
Thanks for your insight!
This post was edited by George Cameron at 08:10:11 04/22/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
