Posted by mkirsch on April 30, 2014 at 05:48:16 from (65.199.189.6):
In Reply to: 240 and 211/311 plow posted by mkirsch on April 29, 2014 at 06:19:04:
I'll let you know how it worked if and when it happens.
Right now, I'm waiting for a friend of mine to turn me a new control shaft for the tel-a-depth quadrant. The small end that holds the handle twisted off in my hands. Poor design, only lasted 55 years. I welded it but it broke again when I tried to put it back together.
The ground out at the farm might not be a good place to test this, though. It's tough plowing ground, always has been. The 240 doesn't have any ballast either, so it may just be embarrassing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
