Posted by Danby on May 07, 2014 at 12:51:21 from (207.170.205.40):
In Reply to: Starting my 300U posted by Danby on May 05, 2014 at 22:10:45:
I'd like to thank everybody that provided suggestions, Wayne especially. Following his instructions led to the discovery that I had offset the plug wires by 1 so that wire #1 was at wire #4's post on the distributor, etc. That's fixed and now I can reliably backfire.
Seems the choke pivot pin is loose and will the choke will close itself with vibration. Also, I appear to be flooding, or maybe the backfire splashed gas into the lower part of the carb.
Either way, I'm pulling the carb tomorrow and fixing it.
Also, the rotor seems a bit loose to me. I'm used to a little wobble, but I can wiggle it some 30 degrees or so. Is that normal? It seems too much for gear lash. Or am I just working the vacuum advance?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
