Posted by krob on May 24, 2014 at 09:01:14 from (69.30.239.250):
In Reply to: farmall 400 drawbar posted by Trkr on May 23, 2014 at 18:00:09:
[quote:c9ad326cb6="D Slater"](quoted from post at 03:41:52 05/24/14) If you have the 2 point hitch that has parts that mount on top of the transmission top? Swinging drawbar for that was a channel iron one with thick metal welded on the front and rear. Also had a thick piece of steel that hooked over the 2 point drawbar. Need to weld something up on that for a roller or make a complete one.
If you have a 2 point with traction control? Has a handle with notches on the left. Swinging drawbar for it was solid steel bar and also had a steel opening welded on top that hooked over the 2 point drawbar.
Don't know your location but I have one of those drawbars someone modified to use a roller. Would sell reasonable.[/quote:c9ad326cb6][quote
I am located in nw mo 45 minutes east of St. Joseph. After seeing it on the parts page, not sure it will help me with the wire roller, but I might still be interested in having one for it. Where are you located?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Dad's 1945 Farmall A - by Bobby Duke Jr.. I am writing about my Dad's 1945 Farmall A. The tractor was purchased in 1945 by his father, Mr. Davis Duke. It was used to farm tobacco from 1945 to 1963 by my grandfather and by my father.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
