|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: pto help
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim M on December 26, 2000 at 15:15:39 from (204.214.132.134):
In Reply to: Re: Re: Re: Re: Re: pto help posted by T_Bone on December 25, 2000 at 19:06:42:
T_Bone,
well, I didn't have any luck gettin that pin out but, I got the casting number from the left side of the housing. The number is 9091. At first I thought it was 9891 but I scraped some grease off and it looks more like an 0. Do I need to find a real skinny magnet to get that pin out or will holding a big one up to the hole pull it out? I tried with a magnetic screw driver but it wasn't strong enough of a magnet to pull it out. When I would push the screw driver on the pin the lever that engages the pto and belt pulley moves. Thanks for all of the help. I appreicate it. Tim
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - Tractor Engine Repair - by Teri Burkholder. One of the great things about working on a tractor engine with your other half is that you know what he is thinking of at all times and can anticipate his every move and his next thought of what he will do. With Ben, anyway, I can tell! He'll be busy working and I’m handing him tools and he says, "give me that..." and I’ve already got it in his hand or "hand me that....."and I’ve got the portable light right where he needed it placed to see. "Run in the house and get me a...."as I open th
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
