Posted by farmallhal on July 27, 2014 at 17:23:34 from (76.2.172.244):
In Reply to: Hay rake ID posted by charlie M on July 27, 2014 at 10:25:21:
Didn't see your response earlier that indicated your rake is like the one pictured by Kopeck except for the rubber tires and your paint is long gone. The correct tooth in my parts catalog for the Side Rake and Tedder model is R 1 007 RF and if your rake was produced after 1919 (most likely) you need a total of 45 unless it is a bean model in which case you need 48 total. I looked at Messicks on-line catalog and that no. isn't in their system as it has probably been superseded to something new. You probably need to take an existing tooth from your rake to a CaseIH dealership and try to match them up with what is available at this time for your rake. HTH, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
