Posted by wayne in mn on July 28, 2014 at 11:36:42 from (71.8.150.168):
In Reply to: Re: Frozen key way posted by rustyfarmall on July 28, 2014 at 07:56:12:
Take the side cutter & grind the sides of it so that both cutting edges are shaped like a wood chisel. (single taper on each half of the plier, not two like it was from the store). This will let you get the plier cutting edge right down on the shaft and will give you the best grip to remove the half-moon key. Grip the key firmly and rotate the handle upward in a prying motion. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
