Posted by Wheaty on August 30, 2014 at 15:57:47 from (199.180.235.245):
In Reply to: WD9, what do I do? posted by Wheaty on August 27, 2014 at 15:40:04:
Update.
Machine shop guy came out today to take a look at the project. The crank, he thought looked pretty good. The bearings that came out of it are at .002. That was both main and rods. He didn't see anything immediate on the head as far as cracks go, but said he would want to tear into it a little further before we go much further. He did say, how ever that the pistons didn't look too bad, and that we might still be able to use them. YEAH !!
I did get in contact with someone on a full rebuild kit, Pistons, sleeves, bearings, gaskets, less valves for the head. and yeah, expensive..... But, he had EVERYTHING...
Sflem849, Al Baker, Randy Reidlinger.. How do I go about getting in touch with you guys on your parts?
Thanks again for all the help !!
This post was edited by Wheaty at 16:03:56 08/30/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.