Posted by Senator on September 07, 2014 at 12:08:14 from (184.76.11.7):
Bought a M yesterday, 1944 - gasoline engine, magneto ignition. The thing ran great, "purred" in fact. Drove it around, started and stopped it 4 times, made the deal, loaded it on the trailer and brought it home. Well, this morning went to get it off the trailer and now it"s backfiring, pretty bad in fact.
So I guess all that is a preamble for my question. I am very familiar with H"s (have two), but do not have a manual for M"s. Until I get one, are the tune-up specs(timing, point settings, etc) pretty much the same on M"s? I"m gonna dig into this thing later today and try to figure out the issue.
At this time I"m assuming ignition might be the problem, but any other ideas would be appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.