Posted by J.Wondergem on November 30, 2014 at 12:54:40 from (97.95.103.142):
In Reply to: timing on super h posted by chuckj1954 on November 30, 2014 at 08:27:43:
chuckj1954 said: (quoted from post at 12:27:43 11/30/14) thanks Wayne, this is very descriptive and thank you. I'm imagining that, even before I follow your instructions in your first paragraph, I should have number 1 at tdc, which would have me on the pully mark to start, yes? sorry for the dumb question. thanks
Yes, but keep in mind the mark will show 180 off as well as on the money. If you take all the plugs out and keep one thumb in number 1 hole while you turn the crank over with the other hand you can feel the pressure coming to top dead center.
This post was edited by J.Wondergem at 12:57:42 11/30/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Great Escape - by Dave Hollrah. It all began Monday with a little baling of second crop on the lake shore field, and as I drove out past my sister and her hubby's place, this small calling sound could be heard from the general direction of their manure pile. Out of the yard, over the cows and bale piles, through the dozer piles, poplars, and brush, out onto the ditch grade road, past the noisy 6.2 diesel engine pulling my well traveled Suburban along. Well it sure didn't take me long to figure out what it was because I alrea
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
