Well ya had all the comments from everybody that think they know 706 gassers . I can tell ya that i know every nut and bolt in a 706 and tell ya what wrenches ya need to do the job. We still run 2 706 gassers and i have lost count of the ones i have bought and sold . If a 706 gasser was at a sale that i was at i owned it when the hammer went down . Dead row thru the ring i would buy them . Take them home and do what was needed to make a usable tractor . Most needed a T/A and they got a new clutch and T/A with warranty , made for a good selling point as the warranty paper work went with the tractor . As far as head cracking i have never seen a head on a C221- C301 crack , Warp yes Crack NO Did a ton of valve jobs on them replaced lots of head gskt. Each and everytime i had a head off it was checked for cracks and never a one found . Warped heads now that is another thing they all need run across the head surfacer as to how much that can vary , valve guides yep they will need them if your doing a good valve job . Ya want it to run good and stay running good then use only LOW ASH oil in it , now some of the EXPERTS will say well i run what ever it's his tractor and he is the one that foots the bill as i have been down this road . That is why i run LOW ASH NOW . We use our 706's each and everyday in all weather . The only thing that we do not do anymore is tillage work with them . Gas is another BIGGIE with them ya need a Min. of93 octane if your going to work them . IF your usen them for pulling a wagon in the local peraid then if your a cheap skate then run what ever ya want here again i really don't care. Ya may want to upgrade to the spring loaded park loc. for safety as that was one other thing i would do to any that came thru my doors . about a 165 bucks .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
