Posted by Oregon Tractor Jack on December 17, 2014 at 12:43:16 from (50.137.138.152):
In Reply to: ih 350 grille repair posted by k1hb on December 17, 2014 at 10:39:05:
Build your own. I have restored two H's, a W6 and a A using a homemade dolly and a pick hammer. Two of the grilles were about half of there normal depth due to being run into fences and the like. I cut down a piece of flat bar to the inside thickness of the louvers. I then ground it down to a rounded shape similar to the shape of some of my other normal dollies. When I was happy with the shape and fit, I welded it to a chunk of 1-1/2 square stock to add mass. This helps support the louvers while you straighten them. I use a normal body hammer and just whittle away at it. Of course there will always be some Bondo. The nice thing about these old grilles is they are very soft and very thick metal. I did this before I saw the adds for the tooling set. They would be nice, but buying one for every tractor is a waste. If you are like me, money is an issue. I have plenty of time...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
