WHENi WAS A KID MY DAD BOUGHT A USED ONE FOR THE 300u. I HATE that stupid lock key!!!! Anyhow... It is still in use and do you know if that wear bar is still orderable? I might just make one. The broken "handle" can be replaced with a cut out piece of 1/2" plate with a tourch and grinder and a pile of washers. That is what ours had till I bought a real one years ago. Does a heck of a job on your drive way too. Spread blue jingle fines and wait till it rains. Spreads like butter and sets up very nice. Lots of cost on the front end but you will mess with it VERY little from then on. Almost as good as paved. Nice job!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
