Farmall & IHC Tractors Discussion Board |
Re: Super A 3pt Hitch Capacity ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Phil Auten (TX) on January 25, 2001 at 19:09:21 from (64.217.53.165):
In Reply to: Super A 3pt Hitch Capacity ? posted by Von Bedenbaugh on January 25, 2001 at 13:09:54:
Von, I think you'll be ok. The touch control unit will lift around 750 lbs and the 3-point limit of 600 lbs that someone mentioned sounds about right to me. I have a 5' pull type shredder and it doesen't weigh 500lbs, my 5' box blade is less than that and a 5' disc shouldn't exceed 500 lbs either. If the front comes up, try adding some weight to the front end. These old tractors are a lot stouter than you would think. Phil
Follow Ups:
Home
| Forums
Today's Featured Article -
The Fordson F Ignition System - by Anthony West. A fellow restorer contacted me earlier this year asking for some help and advice on a model F that he was restoring. He had over a period of months spent a fair amount of his hard earned cash on replacement parts for the old "trembler" ignition. Sadly though all his efforts seemed to be a waste of time and money as he still couldn''t get the temperamental old thing to run correctly!! If i said that this was a little frustrating for him that would be "conservative" in fact the problem had reduce
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|