Posted by CN Vang on April 08, 2010 at 13:55:15 from (64.132.110.210):
I have a Ford 4000 3-cylinder diesel between 1970-1975. I posted a message in regard to a hydraulic problem on this forum earlier. They suggested that I open the lift control valve cover to check for stick unload valve. I did and discovered that something was missing between the top cover hole and the hydraulic fluid return pipe (exhaust pipe). The return pipe was about an inch lowered below the top cover hole and it has a rubber ring on the return pipe which I believe it has some kind of extension or bushing to extend between the return pipe and the top cover hole. Does anyone know if there’s any kind of extension or bushing around that area? If it does, what is it and what is called? If anyone can give me the part number that will be helpful. I will try to attached the hydraulic lift control cover. The red square marked is what I referred to.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
