Posted by Robert Marangoni on April 10, 2011 at 16:24:23 from (75.189.141.49):
This tractor has quiet a few problems with hydraulics so let me start by asking what configuration of flex coupling shaft belongs on the Vickers pump mounted on the front push bar to engine crank pulley. The person that I bought this tractor from had problems with this shaft of some sort or another and was unable to describe exactly what was done with it since it had been so long since it sat in the weeds. The shaft was out and we had to scrounge for the parts on the ground. One end of the shaft has a welded coupling on it, the other is keyed and I had to drill out the set screw and weld a nut over so I could still lock in the key after getting the two apart. The third coupling is a rubber bushing splined version that goes on the pump spline. If I had a resource I would be a new version that had more cushion and vibration absorbing qualities. This one seems to be much to rigid and thats probably why the front seal of the crank leaks so bad and why the shaft sheared or had problems in the first place. Thanks for any help Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Dad's 1945 Farmall A - by Bobby Duke Jr.. I am writing about my Dad's 1945 Farmall A. The tractor was purchased in 1945 by his father, Mr. Davis Duke. It was used to farm tobacco from 1945 to 1963 by my grandfather and by my father.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
