John Deere Tractors Discussion Board |
Re: 4020 3-POINT QUESTION
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill E. on December 19, 2000 at 03:41:32 from (205.232.94.135):
In Reply to: 4020 3-POINT QUESTION posted by Jim on December 18, 2000 at 09:29:41:
Jim, As Oaktree says, try the different draft control settings to see if it makes a difference. I would also check your console to make sure the stops aren't interfering. There's the threaded one for depth and an eccentric one for a height stop. The simple things first. If still binding or stopping, unhook linkage from the arm on the side of the control valve and move it by hand. Also the linkage to the console should flop around. Try these and post back. twopop mentions a cable. The cable was used on pre-'69 models. I've had the problem on my 3020, but it doesn't apply if this tractor is a side console. bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Listening to Your Tractor - by Curtis Von Fange. Years ago there was a TV show about a talking car. Unless you are from another planet, physically or otherwise, I don’t think our internal combustion buddies will talk and tell us their problems. But, on the other hand, there is a secret language that our mechanical companions readily do speak. It is an interesting form of communication that involves all the senses of the listener. In this series we are going to investigate and learn the basic rudimentary skills of understanding this lingo.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|