Posted by gmccool on February 24, 2017 at 17:55:56 from (38.121.112.216):
In Reply to: collector cast seat posted by ckain(mi) on February 24, 2017 at 11:01:36:
I'll give you a little info on your seat. I went to a old cast iron seat collectors book that I have & realized it was a 1985 book but I looked it up anyway & found it is a #601 So then I googled # 601 cast iron seat & found that you have posted a question & picture with the Cast Iron Seat Collectors. (hopefully someone will answer you). Now you need to understand that there are seats with manufactures names on them & seats without manufactures names on them. Both being numbered for identification. DO NOT mistake this seat as a #601 with a manufactures name because it is NOT. It is #601 without a manufactures name. I hope I'm not confusing you but it now gets more complicated. Like I said my book is a 1985 or #IV. Prior to my book there was a #III, #II, & a #I With all these prior books showing your seat with a different #. Now I would GUESS that since 1985 there have been many updates & additions & # changes to this book. So is your seat still #601 with no manufactures name. I doubt it. Sorry I couldn't help you with some more current info. Gerald
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
