I still was pulling bearing parts / pins out of my little MF205 Hopefully I got all out / Have to probably try some more but maget sticks to case when trying to fish out pieces - I've drained and mopped out all OIL - NO ground up metal ... ! TRYING TO FIGURE WHAT WENT BAD ! See my attached PIX : 12 of the round pins like bearings and 14 of the different shaped pins with slots on ends . Anout 1/4" dia and 1" long... also some spring material like what ever held it all together.
Big problem is you can't see down in the tranny to tell what is what ! I have a IT shop manual but doesn't really show what is what regardinf PTO !
I was thinking the MF205 apparently has a a JUNK PTO so maybe just put tranny cover back on and forget the PTO .... We have had 16" of snow predicted so wanted to use it.. John
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
