Posted by larry@stinescorner on May 07, 2011 at 04:26:20 from (71.251.33.236):
a new steam line had to be put under a hallway between to buildings,and in the process there was a large void under the floor of the hallway, We were hired to put a form on each side around the pipe and a company came and pumped in a clay like material with portland mixed in it to fill the void, We pumped in 9 yds of material, The hose went into the hallway and holes were drilled in the floor,and the mix was pumped in. The mixer truck was full when it arrived,and we transferd a load from another dump truck into the mixer truck as the day went on , Had to work late to lock eveverything up, rushed to get to see my daughter leaving for the prom,Then go to the nursing home to see my mom to make sure she is doing ok. It was quite a day. At the end of the day my boss called from his fishing trip in Florida and said how did everything go? I said fine!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
