Posted by Hotflashjr on May 10, 2011 at 07:49:54 from (199.144.39.29):
In Reply to: Wind Farms posted by The Dukester on May 10, 2011 at 07:40:50:
I have worked with a few farmers putting wind generators on their property. It's always a big issue, no one wants them in their backyard blocking their view. It honestly is a way to help a farmer stay in business, reduce their utility bill, and maybe make a few extra bucks. I am all for it if that is the way it is going. If it is someone not farming and just wanting to plop 8 of them down then I am not as supportive. We have seen a few "get rich" type schemes with these at work for people with land, but aren't traditonal farmers. Just about every state and Federal Agency does not consider wind turbines "farming". Typically a lengthy study needs to be done to determine if it is even feasible to put one of these up. At a cost of $400,000 for a half megawatt generator and up most people are going to put them in an area worth while. It's really a toss up... look at a wind mill and buy energy a neighbor made or energy that was created from oil/coal/nukes. And just as a reference, the last project I worked with the 3 lane highway a quarter of a mile from the subdevelopment complaining about the turbines made about 30 decibels higher ambient noise then the 5 proposed 3 megawatt generators would have. Study was done by an indpenedent group not affiliated with the farmer or the people in the development that the town hired.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.